Installation Sheet

(For downrod mount only):
Thread the motor wires through the
downrod stand cover, decorative cap
(Making sure the smooth side of
decorative cap is facing downward),
canopy and downrod.
Tighten the hanger bracket to the outlet box
with two mounting screws. (To reduce the
risk of fire, electric shock, or personal injury,
mount to an outlet box marked “ Acceptable
for fan support” and use mounting screws
provided with the outlet box.)
Note: For slope ceiling installation, make
sure that the chip of the hanger bracket
is toward the floor.
Turn OFF the electric circuit at the
main fuse or circuit breaker box.
(For ceiling mount only):
Remove the canopy cover from the
canopy.
Remove downrod stand cover and
three of six screws (every other one)
securing the motor collar to the top
of the fan motor housing. Attach the
canopy to the housing with three screws.
Go to Fig.10 for the next step.
( For ceiling mount only):
Raise the fan and place the canopy
on the hanger bracket hook for wiring.
Fig.4
Hanger Bracket
Hook
(For downrod mount only):
Remove the lock pin and take off
the hanger pin.
(For downrod mount only):
Loosen the collar screws out part way.
Insert the downrod into the collar.
Slide hanger pin through holes of
collar and downrod.
(For downrod mount only):
Tighten the two collar screws.
Slide lock pin into hanger pin until
it is locked into position.
14.99
6.8
210329