Installation Sheet

PAGE: 9 / 11
F A N C O
181008
Blue
Green (Ground)
Fig.25
Fig.26
Turn ON the electric circuit at the
main fuse or circuit breaker box.
Install Without Remote Controller
Fig.23
Turn OFF the electric circuit at the main fuse or circuit breaker box. (See Fig.23)
Unscrew the canopy. Remove the wire connectors from the fan to ceiling
wire connections. Slide the receiver in the Hanger Bracket with the flat
side toward the ceiling. (See Fig. 24)
Fig.24
Receiver
Hanger Bracket
Canopy
Connect wires: (See Fig.25)
1). The white (neutral) motor wire to the white (neutral) wire from the outlet box with a wire connector.
2). The black (hot) motor wire and blue (hot) wire to the black wire from the outlet box with
a wire connector.
3). The green (ground) wire from the downrod to the ground wire from the outlet box
with a wire connector.
*** After making the wire connections, the wires should be spread apart with the
white (neutral) conductor and the green (ground) conductor on one side
and the black (hot) conductor on the other side of the outlet box.
*** The wire connection points should be turned upward and pushed carefully up
into the outlet box.
Note: Remote control can not be worked along with solid-state speed control at the same time.