Installation Sheet

ManualsBrandsVaxcel ManualsChandeliersVaxcel Lighting Astor 6 Light 26" Wide Chandelier with Glass Shades

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

H0227

WARNING:

AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER WHILE INSTALLING OR SERVICING THIS FIXTURE.

181126

Turn off the power at fuse or circuit box.

Installation Steps

1. Put the hex nut on the fixture, and secure it with finial tightly.

2. Rod Connections:

a. Thread the fixture wire from the fixture through the lower rod,

then secure the lower rod onto fixture using the threaded pipe.

b. Thread the fixture wire through the middle rod, and then secure

the middle rod onto the lower rod using the threaded pipe.

c. Thread the fixture wire through the upper rod, and then secure

the upper rod onto the middle rod using the threaded pipe.

Note: Length adjustable from 23-3/8" to 77-3/8". Use fewer

rods if shorter length is desired.

3. Thread two fixture mounting screws to the mounting strap, then

secure them with two lock nuts. Adjust the length of the fixture

mounting screws if necessary.

4. Attach the mounting strap to outlet box by using two

mounting screws.

5. Thread the fixture wire through the canopy, then secure

the upper rod to the canopy with the set nipple.

6. Pull out the source wires from the outlex box. Make wire

connections using wire connectors as follows:

---Connect the hot wire (usually black insulation) from the fixture

to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from the fixture

to the white wire from the power source.

---Attach the fixture grounding wire (usually green insulation or bare

wire) to the mounting plate with the green grounding screw, and

then connect it to the house grounding wire with the wire connector.

Carefully put the wires back into the outlet box.

Hardware Package (included):

Fixture Mounting screw (E)

Mounting Screw (B) Green Grounding Screw (C)

Wire Connector (D)

Lock Nut (F)

Mounting Strap (A)

Ball Nut (G)

Outlet Box

House Grounding Wire

Fixture Grounding Wire

Fixture Mounting Screw (E)

Upper Rod

Threaded Pipe

Nipple

Ball Nut (G)

Canopy

Wire Connector (D)

Lock Nut (F)

Mounting Screw (B)

Green Grounding Screw (C)

Mounting Strap (A)

Middle Rod

Lower Rod

Fixture Nipple

Frame

Finial

Hex Nut

Glass Holder

Down Fixture

Glass Shade

Bulb Type T Max.

60W (not included)

Summary of content (2 pages)

PAGE 1
H0227 ASSEMBLY AND INSTALLATION INSTRUCTIONS WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF POWER WHILE INSTALLING OR SERVICING THIS FIXTURE. NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements. 2. READ AND SAVE THESE INSTRUCTIONS.
PAGE 2
7. Attach the canopy to the mounting strap by inserting the nipple, then secure it with two ball nuts. 8. Install six bulbs (not included). See relamping label at socket area or packaging for maximum allowed wattage. 9. Attach the glass shades to the glass holders directly. Turn on the power at fuse or circuit box. The following parts are available for re-order if damaged or missing.