Specifications

21
DE-M070701E • DEWE-50-USB2-16 • Technical Reference Manual • Printing version 1.0.4 • April 16, 2008
DEWE-50-USB2-16
DEWE-50-USB2-16 installation guide
System requirements
Windows 2000 / XP
Intel Pentium 4, 1 GHz processor or higher
512 MB RAM
50 MB free hard disk space
USB2.0 port
Hardware driver installation
CAUTION: do not connect the DEWE-50-USB2-16 to the PC until all the drivers are installed!
• Insert the DEWE-System DVD
• Change to the directory \Install\Drivers\6_DAQBoards\DT
• Start the SetupOEMWin32.exe and follow the instructions.
• This will install the basic AD-board driver to your computer.
• Change to \Install\Drivers\7_Communication\DEWE-USB
• Start TI3410inst.exe
• This will install the internal USB to RS485 converter driver.
• Connect the DEWE-50-USB2 to the power supply
and turn it on.
• Connect the DEWE-50-USB2 to a USB2.0 port of the PC.
• The operating system will automatically detect the new
device and install the appropriate driver.
• Follow the individual driver setups from the AD-board
and the USB-serial-converter.
• The vector CAN driver is automatically detected
on the DEWE-System DVD.
• After nishing restart your computer.
• Check in the device manager if everything is installed properly.
If there is a device missing or marked with a yellow sign proceed
with trouble shooting on page..
• Keep the COM port number of the USB-serial-port within mind.
It is the port that has to be selected in DEWESoft.
WARNING: It is strongly recommended to connect the DEWE-50 to the same USB connector of the
computer all the time. Otherwise the COM port number changes and the installation becomes slow.