Specifications
22
DEWE-50-USB2-16
DEWESoft conguration
• To congure your modules in the DEWETRON-system please install the software “DEWESoft”
from your system-DVD and choose the option “DEWESoft for DEWECong mode” After the
installation please start DEWESoft and enter the COM port where your modules are connected.
(Note: Please don´t change the setting “Analog device” - it should be set to “No A/D Hardware”).
Conrm the new settings with “OK”, exit this menu and choose “Setup”. Inthis overview
you can add / remove modules and change the ranges and the addresses.
(A detailed description can be found in the online manual of DEWESoft.)
NOTE: This steps above only have to be made if you did not order DEWESoft with your DEWE-50-USB2-
16 and want to install your system afterwards. Otherwise refer to the following steps of the DEWESoft
conguration chapter.
After installing DEWESoft you have to make following settings in the hardware setup:
• Select as analog device “Data translation”
• Select as COM port the internal USB-serial-port of the DEWE-50-USB2-16. It is listed as “USB-serial-
port” in your device manager
CAN setup (AUTO option)
Select the vector CAN driver in DEWESoft