VEC013DB Jump-Start System 12VOLT DC POWER SUPPLY OWNER’S MANUAL AND WARRANTY INFORMATION THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY, OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT. READ CAREFULLY BEFORE USE, AND RETAIN FOR FUTURE REFERENCE. 4140 S.W. 28th Way, Ft.
SAFETY INFORMATION WARNINGS: 1. When working with lead-acid batteries, always make sure immediate assistance is available in case of accident or emergency. 2. Always use protective eyewear when using this product: contact with battery acid may cause blindness and/or severe burns, be aware of first aid procedures in case of accidental contact with battery acid. 3. There is a risk of explosive gases being released when lead acid batteries are being charged or discharged.
. Never insert anything other than the supplied power/recharging cords or recommended appliance power/recharging cords into the 12 volt DC charging/ power socket on this unit. Do not use any accessory that is not recommended or provided by the manufacturer. 4. Do not use this unit to operate appliances that draw more than 5 amps. 5. This system is designed to be used only on vehicles with 12 volt DC battery systems. Do not connect to a 6 volt or 24 volt battery system. 6.
INTRODUCTION Congratulations on selecting the Durabilt Jump-Start System. This compact jumpstarter is unique in the amount of energy it can supply for its size. The internal battery is a high-density sealed, lead-acid battery that stores and delivers energy comparable to full sized ordinary jump-starters. Please read this guide carefully before use to ensure optimum performance and avoid damage to the unit or items that you are using it with.
10 1 2 3 5 4 6 7 8 FIGURE 1A (Front Panel View) 1. 2. 3. 4. 5. 6. 7. 8. 9. 10.
JUMP STARTING INSTRUCTIONS Connect – Red clamp first, then black clamp. Disconnect – Black clamp first, then red clamp. 1. Turn OFF vehicle ignition and all accessories (radio, A/C, lights, cell phone, etc.). Place vehicle in “Park” and set the emergency brake. 2. Make sure jump-start system’s ON/OFF power switch is turned to OFF. 3. Remove jumper cables from clamp holder. 4. Procedure for jump-starting a NEGATIVE GROUNDED SYSTEM (NEGATIVE BATTERY TERMINAL IS CONNECTED TO CHASSIS). (MOST COMMON) 4a.
6. Always disconnect the engine or frame jumper clamp first; followed by the battery jumper clamp. 7. Never allow red and black clamps to touch each other or another common metal conductor; this could cause damage to the unit and/or create sparking/explosion hazard. 8. There is a risk of explosive gases being released when batteries are charged or discharged, failure to follow instructions may cause property damage, explosive hazard, and/or personal injury. 9.
WARNING: • Always use protective eyewear when using this product: contact with battery acid may cause blindness and/or severe burns. • Keep out of children’s reach. FIRST AID: SKIN: If battery acid comes in contact with skin, rinse immediately with running water, then wash thoroughly with soap and water. If redness, pain or irritation occurs, seek immediate medical attention.
12 VOLT DC CHARGING 1. Insert the plug that is marked “TO VEHICLE ACCESSORY OUTLET” of the DC/DC charging adapter into the 12 volt DC accessory receptacle on the vehicle or boat. 2. Insert the plug at the other end of this charging adapter marked “TO JUMP STARTER OUTLET” into recharging port on the front panel of the unit. 3. Charge the unit until the green FULL indicator lights when Charge Switch Indicator Button is pressed. DO NOT EXCEED 4-5 HOURS MAXIMUM. 4.
Battery Disposal: This unit contains a maintenance-free, non-spillable, sealed leadacid battery. This battery is fully recyclable and should be accepted at any location that accepts common automotive starter batteries. Examples of places that accept these batteries are: County or municipal recycling drop-off centers, scrap metal dealers and retailers who sell automotive replacement lead acid starter batteries. For more information on recycling this battery, call toll-free (877) 288-7722.
2 YEAR LIMITED WARRANTY PROGRAM This limited warranty program is the only one that applies to this product, and it sets forth all the responsibilities of Durabilt, regarding this product. There is no other warranty, other than those described herein. This Durabilt product is warranted, to the original purchaser only, to be free of defects in materials and workmanship for two years from the date of purchase without additional charge. The warranty does not extend to subsequent purchasers or users.