Full Product Manual

PERIODIC SERVICE 11-10
Battery type
Volts
12V32Ah
12
Direction for storage
1. When storing the vehicle for a long period,
remove the battery from level vehicle, store in
a dry place out of direct sunlight.
2. The battery shall self discharge while it is
shored recharge it once every three months in
hot seasons and once every six months in
cold seasons.
Adjusting toe-in
Proper toe-in
0 to12 mm (0 to 0.47 in)
1. Park vehicle on flat place.
2. Turn steering wheel so the front wheels are in
the straight ahead position.
3. Set the parking brake and stop the engine.
4. Measure distance between tire beads at rear
of tire at hub height.
5. The front distance should be shorter than rear
distance. If not, adjust tie rod length.
Wheel-to-wheel distance at front
FRONT
Adjusting procedures
1. Loosen the lock nut and turn the tie rod to
adjust the rod length until the proper toe-in
measurement is obtained.
2. Retighten the lock nut.
IMPORTANT
Keep an equal length between the left and
right tie-rod.
Cleaning Muffler
CAUTION
To avoid personal injury:
Before touching any part of an exhaust
system, be absolutely sure that it has
sufficient time to cool!
Always wear safety goggles and face
mask.
The particulate matter contained in the
muffler contains chemicals that are
harmful to people, animals and marine life.
If you are unable to do this work, have it
done by your dealer.
Cleaning spark arrester of muffler.
Maintenance & cleanout procedure:
The screen type spark arrester should be removed,
cleaned, and inspected after every 100 hours
of use.
1. The spark arrester is located inside of the
exhaust pipe, and fastened with six bolts.
2. Loosen the bolts and remove the spark
arrester.
3. Shake loose particles out of the screen
assembly and lightly clean the screen with
wire brush. Soak in solvent and again clean
with wire brush if necessary.
4. If any breaks in the screen or weldments are
discovered, the assembly must be replaced.
5. Return the spark arrester to the muffler body
and refasten the bolts.