Instruction Manual

Overview of the controls for the VMB1TC temperature controller (rev. 4)
Remarks:
1. This menu is only accessible if the temporary mode (sleep timer) is activated.
2. This menu is not accessible if a zone or “all rooms” are selected.
3. This menu is not accessible if “all rooms” are selected.
Direct control
Button Action
Location
Modify sensor or zone.
The previous/next room (zone) can be selected
with the “↑“ or “↓” button as long as the LED of
these buttons blinks.
Mode
Temporarily switch between antifreeze -, night
, day or comfort
Remark: a long press will deactivate the
temporary mode (sleep timer)
‘↑’ ‘↓’
Display and/or modify desired temperature
Menu
Short press: call abridged menu
Long press: call full menu
Menu control
Navigate through the menu with the “↑” and “↓”
buttons.
Select an item with the “→” button.
Confirm a setting with the “→” button or clear the
setting with the “←” button.
Quit the menu at any time without saving the
modifications with the “5” button.
Short menu
Press the “Menu” button shortly to call the menu.
Sleep timer
1
Temp. settings
Comfort
Day temp
Night temp
To main menu
Alarm clock set
Clock set
Exit
Extended menu
Hold the “Menu” button pressed to call the extended
menu. Enter the PIN code if necessary.
Program
Sensor Settings
Operating mode
Button lock
Sleep timer
Low temp. alarm
High temp. alarm
Anti-freeze temp
Upper heat temp
Lower cool temp
Upper cool temp
Hysteresis
Temp difference
Unjam pump
Unjam valve
Local program
Zone number
2
Diff. sensor
2
Sensor cal.
2
Change name
3
To main menu
Configuration
Language
Temp. Read-out
Master clock
Global alarm clk
Battery backup
Change PIN code
Firmware version
Address
2
Link wake-up
2
Link go-to-bed
2
Scan sensors
2
To main menu
Display
Contrast
Backlight
To main menu
Statistics
2
Min temp 16.0°
Max temp 23.0°
- 0m/5m
0m/5m
8m/1h10m
10m/1h15m
18m/2h35m
To main menu
Exit
Location
5
↑
↓
Menu
→
Mode
←
Living
Ma 14:23 21