Manual

VDSMB14/15 HQPOWER

DYNAMIC 2-WAY SPEAKERS

1. Introduction

To all residents of the European Union

Important environmental information about this product

This symbol on the device or the package indicates that disposal of the device

after its lifecycle could harm the environment. Do not dispose of the unit (or

batteries) as unsorted municipal waste; it should be taken to a specialized

company for recycling. This device should be returned to your distributor or to

a local recycling service. Respect the local environmental rules.

If in doubt, contact your local waste disposal authorities.

Thank you for choosing HQPOWER! Please read the manual thoroughly before bringing this

device into service. If the device was damaged in transit, don't install or use it and contact

your dealer. Damage caused by disregard of certain guidelines in this manual is not

covered by the warranty and the dealer will not accept responsibility for any ensuing

defects or problems.

2. Installing

1. The speakers are manufactured to resist a variety of weather

conditions. However, they are not waterproof. If you decide to

install your speakers outdoors, position them so they will not

be exposed to the elements. The underside of most eaves and

overhangs provide the best protection for indoor/outdoor

loudspeakers.

Like all speakers, the sound is best when the speakers are

placed no more than 7 ft (± 2 metres) apart, ear level to the

listener. If the speakers are farther apart, toe them in toward

the centre of the room. Do not place them within 2 ft of a

television set or computer screen as these speakers are not

video shielded.

2. If your application requires your speakers to be mounted,

please follow these directions. Using the supplied hardware,

mount the bracket first. Attach the speakers to the brackets

using the supplied large plastic knobs. Never mount a speaker

on a wall made of unreinforced drywall or plasterboard. When

in doubt, consult a professional contractor.

3. The speaker terminals will accommodate up to 12-gauge wire. When

connecting the speakers, it is very important to observe the correct

polarity. This means that the wire attached to the (+), red or

positive terminal on one component must be attached to the (+),

red or positive terminal on the corresponding output terminal of the

component to connect. Similarly, the (-), black, negative or ground

terminal must be connected to the respective (-), black, negative or

ground terminal.