User Manual

P a g e | 9
4. Hold the SETUP button (9) on the receiver for at least 3 seconds until the CH2 LED (8) will turn
on.
5. Again, hold the SETUP button (9) on the receiver for 3 seconds until the CH2 LED (8) will turn off.
6. All transmitters are now cleared from the receiver’s memory.
Please note you will need to re-pair a transmitter to the receiver.
Using the VM130V2SET with the Transmitter
Press the CH1 button (2) on the transmitter for minimum 2 seconds to change the state of the CH1
relay (10) on the receiver. If the channel was on, it will turn off (and stay off). If it was off, it will turn
on (and stay on).
Press the CH2 button (3) on the transmitter for minimum 2 seconds to change the state of the CH2
relay (11) on the receiver. If the channel was on, it will turn off (and stay off). If it was off, it will turn
on (and stay on).
The red Indicator LED (4) on the transmitter will flash while you hold the CH1 button (2) or CH2
button (3), indicating transmitting a signal. After 3 seconds, the transmitting will stop automatically
to save the battery.
The receiver shows the status of each channel with the CH1 LED (7) and the CH2 LED (8).
LED on= channel active. LED off = channel deactivated.
Press the LED button (1) to use the flashlight functionality of the transmitter.