Owner`s manual

13
Remote Control Operation (Each symbol means Press Button Once)
BUTTON FUNCTION
PRESS
and INDICATION
The CONTROL PANEL switch must be
ON to use the REMOTE CONTROL.
The POWER button turns on the flame
and enables all functions. Other remote
functions will only work when this is ON.
1. Beep. Flame effect – High intensity.
All other functions are now enabled.
2. Beep. During operation, when
switched OFF, all functions will turn OFF.
The FLAME button allows you to select
one of four flame effects.
It does not control the back lights.
While the Power is ON, the flame is ON.
1. Beep. Flame intensity - High.
2. Beep. Flame intensity - Medium.
3. Beep. Flame intensity - Low.
4. Beep. Flame effect - Multicolor.
The HEATER button controls the left and
right heaters. There are four levels: Low
(Left), Low (Right), High (Both), and Off.
The heater only works when the flame
effects are ON. If the flame effects are
OFF, the heater will not turn on.
To prevent overheating, the heater fans
will blow cool air for 8-10 seconds each
time the heater is turned ON or OFF.
1. Beep. Left heater & fan turn ON; left
pilot light glows ☼

, then turns off.
2. Beep. Right heater & fan turn ON;
right pilot light glows

☼, then turns off.
Left heater and left pilot light turn OFF.
3. Beep. Both heaters & fans turn ON;
both pilot lights glow ☼☼, then turn off
.
4. Beep. Both heaters turn OFF, both
pilot lights turn off.

The SPEED button controls the flame
speed. There are three speed levels.
1. Beep. Flame speed - Fast
2. Beep. Flame speed - Medium
3. Beep. Flame speed – Slow
The BACK LIGHT button controls the LED
light strips at the rear edges of the
fireplace. The five settings are OFF,
Yellow, Blue, Yellow/Blue, and Multicolor.
The back lights work with or without the
other features being turned on.
1. Beep. Back light - Yellow
2. Beep. Back light - Blue
3. Beep. Back light - Yellow + Blue
4. Beep. Back light - Alternating colors
5. Beep. Back light - Off
Meijer.com