Owner`s manual

7
AVOID INJURY and DAMAGE! Four screws should be screwed directly into wall
studs. If that is not possible, at least two screws must be screwed directly into wall
studs, AND four additional screws must also be screwed into the drywall anchors.
STEP 3. Position the wall mount bracket (C) over the wall studs. Level the mounting bracket and
mark the four holes with a pencil. Set the wall mount bracket aside. Drill a pilot hole at each marked
point using a 1/16” wood drill bit. Make sure each hole goes into a wall stud.
STEP 4. Thread one M5x40 wood screw (3) through the bracket, into the pilot hole, and into the
stud. Partially tighten. Make sure the bracket is level.
Thread the remaining three M5x40 wood
screws into the other three holes. Check the alignment and tighten each screw securely with the
Phillips screwdriver. Check each screw to make sure it is tight, and that the bracket is secure.
3
C
3
3
3
Meijer.com