Owner`s manual

Table Of Contents

STEP 5. If only one wall stud is available, the wall mount bracket must be secured to the wall with

two M5x40 wood screws (3) though the two center post holes AND four M4x30 drywall

screws (4) through one other set of bracket holes. DO NOT attach the wall mount bracket to the

wall studs with one of the outer sets of holes as the bracket will not be stable. Use the center holes.

STEP 6. Center the wall mount bracket (C) over the wall stud. Level the mounting bracket and

mark the two center post holes with a pencil. Mark the four outer holes for the drywall anchors. Set

the wall mount bracket aside until STEP 8.

STEP 7. Drill pilot holes into the two center marks using a 1/16” wood drill bit. Make sure each pilot

hole is drilled directly into a wall stud. Next, use a Phillips screwdriver to screw the four drywall

anchors (5) into the drywall until they are flush with the surface. DO NOT OVERTIGHTEN.

Meijer.com