Owner`s manual

9
STEP 8. Thread the two M5x40 wood screws (3) through the center post holes, into the pilot holes,
and into the wall stud. Partially tighten. Make sure the bracket is level. Thread the four M4x30
drywall anchor screws (4) through the wall mount bracket and into drywall anchors.
DO NOT OVER- TIGHTEN as this may loosen the anchors or damage the drywall. Check the
alignment and tighten each screw securely with the Phillips screwdriver. Check that the bracket is
secure.
ALWAYS unplug this fireplace heater before assembly or cleaning
, or before
relocating. Failure to do so could result in electric shock, fire, or personal injury.
STEP 9. With the firebox (A) at an angle, fit the slots in the back of firebox (A) over the hooks on
the wall mount bracket, and carefully press the top of the firebox against the wall mount bracket.
The slots at the top edge of the firebox should slide over the wall mount bracket tabs. Hold the
firebox in place and thread the machine screws (6) through the holes in the firebox and into the wall
mount bracket tabs. Tighten both machine screws and make sure the firebox is secure to the wall.
4
3
3
4
4
4
C
A
6
6
Meijer.com