Installation manual

SYSTEM SUPERVISOR AND SUBSCRIBER GUIDE 9.0 VER. 1
1-16
To issue a broadcast message:
1. From the Supervisors menu, press 5 for System Broadcast Message. The system voices
the following options:
To Hear the Current Broadcast Message Press 1
To Re-record the Broadcast Message Press 2
To Delete the Broadcast Message Press 3
To Exit Press #
2. To record a broadcast message, press 2. Follow the prompts to complete the procedure.
1.3.3 Disabling or Re-enabling a Port over the Telephone
If you want to prevent the VP system from answering calls on one or more of its ports
(usually because the port is not functioning properly), you can disable the port(s) over the
telephone. Should you find later you want to re-enable a port that was previously disabled,
you can also perform this function by calling into the system.
To disable or re-enable a port:
1. From the Supervisors menu, press 4 for Port Administration.
2. When prompted, enter the number of the line with which you want to work.
3. When prompted, press 1 to confirm the number you entered or press # if the number you
entered was incorrect. Once you press 1 to confirm, the system voices the port
administration options:
To Disable a Port Press 1
To Enable a Port Press 2
To Exit Press #