Installation manual

SYSTEM SUPERVISOR AND SUBSCRIBER GUIDE 9.0 VER. 1
1-24
Once you access this menu, be advised that you must not press # to exit it, since the # key
invokes a change to the destination for the pound key. If you want to return to the
previous menu, simply make no entry when you hear the special routing options prompt.
1.4 Performing Supervisor Functions from VP System
Screens
To access program screens on which you can perform supervisor functions you must log onto
the VP system PC using the Customer/Administrator password. The technician who installed
the VP system can provide this password to you.
The procedure you use to access system screens depends on whether the VP system is DOS-
based or NT-based. The VP system technician can inform you which type of system you
have and which procedures you must follow in this document to access program screens.
WARNING:
It is critical you make no modifications to any field on any screen or to any
file on the VP system unless you are directed to by this guide or by the VP
system installation technician. Incorrect modifications you make may impair
the ability of the VP system to perform call processing and messaging
functions.
To access screens through the DOS-based VP system screen interface:
1. From the LINE STATUS screen, press <F10>. The Main menu displays, and you are
prompted to enter a password.
2. Type the password then press <Enter> to log on to the VP system. The Main menu
displays.
The following illustration shows the structure of the DOS-based VP system menus. Note that
depending on the type of VP system installed and the password you entered to log on, you
may not have access to all menus and options.