Installation manual

SYSTEM SUPERVISOR AND SUBSCRIBER GUIDE 9.0 VER. 1
1-37
VP: Pager Number (Page 2 screen)
NTVP: Pager Number (Pager tab)
This field indicates the telephone number of the paging service. The mailbox owner may
change the number remotely. Normally, access codes for outside lines are not required here.
To restrict pager calls to use lines in a particular line group, enter the letter (A, B, C, or D) of
the line group in braces { } before the telephone number (for example, {A}5551212).
Consult the VP system technician for more information.
Tone or Voice pagers can be set up under the Message Delivery portion of this screen.
Consult the VP system technician for more information.
The pager number can contain the digits 0 through 9 and the characters * and pound #, as
well as the several special characters: Consult the VP system technician for more
information.
VP: Pager Type (Page 2 screen)
NTVP: Pager Type area (Pager tab)
The VP system supports both Tone and Display (digital) pagers in this section of the mailbox
programming. This field specifies which type of pager the mailbox owner has.
When a caller asks the VP system to page a mailbox owner, the VP system looks for a free
line on which to call the paging service. If no lines are free to make the call, the VP system
queues the request and re-tries every 10 seconds for about 10 minutes.
VP: Times to Call (Page 2 screen)
NTVP: Call the Pager X times (Pager tab)
The VP system calls the pager the number of times indicated in this field. This can be useful
in circumstances when the pager is turned off for a period or is temporarily out of pager
range.
VP: Minutes Between Calls (Page 2 screen)
NTVP: At Intervals of X Minutes (Pager tab)
If you enter a number greater than 1 in the above field, this field instructs the VP system how
long it is to wait between the re-calls.