Installation manual

SYSTEM SUPERVISOR AND SUBSCRIBER GUIDE 9.0 VER. 1
1-43
NT-based VP system users can view and modify the schedules defined for the mailbox by
clicking on the View Schedules button.
Message Delivery
This section describes each field associated with the message delivery feature.
VP: Call (Page 2 screen)
NTVP: Call (Message Delivery tab)
This field contains the telephone number the VP system is to call to inform the mailbox
owner that there are new message in his/her mailbox.
The field can contain the DTMF digits 0-9, the characters * and #, and other special
characters. Consult the VP system installation technician for information on completing this
field.
The owner of a mailbox can call in and remotely change the first message notification
number, but cannot indicate special characters.
VP: Repeat (Page 2 screen)
NTVP: X Times (Message Delivery tab)
This field indicates the number of successful calls that the VP system is to make to each
telephone number. A successful call is generally defined as one where the VP system has
seized an available line port, dialed the number, and detected an answer. If the call is not
successful (for example, the called number was busy) the VP system automatically re-tries
every few seconds up to twenty times.
VP: Interval (Page 2 screen)
NTVP: Intervals of X (Message Delivery tab)
If the field to the left of this field contains a number greater than 1 or there are additional call
number sequences, this field indicates the interval (in minutes) between calls to this number
and/or the interval before proceeding to the next call number sequence.