Installation manual

SYSTEM SUPERVISOR AND SUBSCRIBER GUIDE 9.0 VER. 1
1-54
1.4.5 Modifying the Greeting Played by a Routing Box through
VP System Screens
Before modifying any Routing box greetings, refer to section 1.3.5 for information on the
Routing box setups on the VP system and Routing box greetings.
Note that if you use the following procedure to change the greeting in a Routing box, you
must update the Routing box call routing structure to relay new instructions to the caller. Use
the procedure presented earlier in this section to update the greeting as necessary.
To modify a Routing box greeting through the DOS-based VP system screen interface:
1. From the Main menu, select BOX INFORMATION. The Box Information menu displays.
2. Highlight ROUTING BOX from the Boxes menu then press <Enter>.
3. Enter the box number you want to modify, then press <Enter>. The box’s setup screen
displays.
4. Adjust the greeting using the ROUTING BOX screen field discussed below. When you
have made necessary modifications, press <F10> to save the changes.
To modify a Routing box greeting through the NT-based VP system screen interface.
1. From the Main screen, access the BOXES pull-down menu.
2. Select ROUTING BOX from the Boxes menu.
3. Select the Select button and choose the number of the box whose greeting you want to
modify. The box displays on-screen.
4. Adjust the greeting using the ROUTING BOX screen field discussed below. When you
have made necessary modifications, select the Save button to save the changes.
1.4.6 Recording a Greeting through the Routing Box Screen
The field description provided below identifies how you record a greeting from the Routing
box screen. The field used in DOS-based VP systems is prefaced below with VP, and field
used in NT-based VP systems is prefaced with NTVP.