Installation manual

SYSTEM SUPERVISOR AND SUBSCRIBER GUIDE 9.0 VER. 1
1-56
Note that if you use the following procedure to change the single-digit call routing set up, you
must update the Routing box greeting to relay new instructions to the caller. Use the
procedure presented earlier in this section to update the greeting as necessary.
To modify call routing through the DOS-based VP system screen interface:
1. From the Main menu, select BOX INFORMATION. The Box Information menu displays.
2. Highlight ROUTING BOX from the Boxes menu then press <Enter>.
3. Enter the box number you want to modify, then press <Enter>. The box’s setup screen
displays.
4. Make changes to the ROUTING BOX screen to modify the call routing used when calls are
sent to this box. For information on modifying fields on this screen, consult the
information provided below and the program’s online help file (accessible by pressing
<F1>). When you have made necessary modifications, press <F10> to save the changes.
To modify call routing through the NT-based VP system screen interface:
1. From the Main screen, access the BOXES pull-down menu.
2. Select ROUTING BOX from the Boxes menu.
3. Select the Select button and choose the number of the box you want to modify or delete.
The box’s setup screen displays.
4. Make changes to the ROUTING BOX screen to modify the call routing used when calls are
sent to this box. For information on modifying fields on this screen, consult the
information provided below and the program’s online help file (accessible by pressing
<F1>). When you have made any necessary modifications, select the Save button to save
the changes.
Working with the Routing Box Screen
Note: See section 1.4.9 for screen illustrations.