Installation manual

SYSTEM SUPERVISOR AND SUBSCRIBER GUIDE 9.0 VER. 1
1-64
VP: Automatically Delete NEW Messages After X Days
NTVP: Automatically Delete NEW Messages After X Days (Messages tab)
Note: Use this parameter with caution. Improper use may cause important
messages to be lost.
The VP system deletes new messages from mailboxes belonging to this class of service after
the number of days you specify. A new message is one the mailbox owner has not yet
listened to. If you enter 0 in this field, a new message is deleted at midnight on the day the
message was received. If you enter 1 in this field, a new message is deleted at midnight on
the day following the day the message was received.
To disable the deletion of new messages, retain the default setting of 99 in this field. This is
the default operating mode. If you enter a number other than 99 in this field, remember
that messages are deleted whether or not the mailbox owner has listened to them.
VP: Supervisor Status
NTVP: Supervisor Status
This field defines whether mailboxes belonging to this class of service should have supervisor
privileges. A supervisor can perform certain actions not available to regular mailbox owners.
For example, a supervisor can add a mailbox or delete a mailbox by calling in from any
telephone. The default setting in class of service 0 is NO, in class of service 7 is YES.
VP: Access to Group Boxes
NTVP: Access to Group Boxes
By setting this field to YES, you allow subscribers assigned this class of service to access all
Group boxes set up on the system. The default setting is YES.
VP: Dial-Out Allowed
NTVP: Dial-Out Allowed
This field indicates whether the owner of a mailbox belonging to this class of service is
allowed to place outgoing calls from the mailbox. The default setting is NO.