User's Manual

Setting and Using SLEEP SET

Your Rise & Shine

allows you to fall asleep gradually, using one of three Sleep

Cycle Durations: 5, 15 or 30 minutes, and other options listed below.

During the cycle, the volume of the sound and/or the brightness of the light will

gradually decrease, allowing you to fall asleep gently.

To use the Sleep option, press the SLEEP button. SLEEP will be shown on the

bottom right of the display.

Sleep setting options are:

• Duration

• Light

• Backlight

• Sound

• Play Mode

You may also set the maximum LED light panel brightness for the start of the

Sleep Cycle.

Choosing SLEEP SETTINGS Options

1. Press the MENU button.

2. The Main Menu is displayed.

3. Use the Rotary Selector Control to highlight SLEEP SET.

4. Press the Selector Button to choose SLEEP SETTINGS.

The SLEEP SETTINGS menu is displayed. The DURATION: 5 MINUTES item is

highlighted (5 MINUTES is the default setting).

Duration Settings

1. Press the Selector Button.

2. From the SLEEP DURATION sub-menu, highlight 5 MINUTES, 15 MINUTES

or 30 MINUTES.

3. Press the Selector Button to choose the highlighted selection.

The display returns to the SLEEP SETTINGS menu.

Light Settings

The Sleep brightness level is only used for the Sleep Cycle. You may set the initial

brightness level for the cycle. When the Sleep Cycle begins, the light will begin at

this level then continue to dim until the duration of the Sleep Cycle ends.

VA04_Man_Rev9.indd 16VA04_Man_Rev9.indd 16 11/4/09 1:38 PM11/4/09 1:38 PM