Instructions Manual

Pub. #OM17-MSP3
5-2
Figure 3 Figure 4
Hubs --Use good quality wheel bearing or lithium grease for lubrication, but we suggest that you
grease the hubs sparingly. Over-lubricating the hub will result in pre-mature seal failure, and an
excessive amount of grease in the hub cap/commutator. On an interval of 150 hours, 1-2 strokes
of grease should be sufficient.
Pinch point hazard: to prevent injury, stand clear when raising or lowering any part of the
Veris MSP3.
Install all transport locks before transporting or working underneath.
Always use the service stands when working underneath the MSP3.
Figure 5 Figure 6
grease zerk