Instructions Manual

Pub. #OM17-MSP3
5-6
Replacing Opening Disk
1. Make a note of current Disk depth
2. Remove the 5/8-11 x 4in bolt, lock washer and nut
3. Replace disk with new disk.
4. Reinstall disk to proper depth.
Figure 16
Opening Disk lubrication
The opening disks each have a grease zerk on them
(right and left side). Due to the constant rotation, these
should be lubricated on 80–hour intervals.
Figure 17
Depth Gauge Wheels lubrication
The depth gauge wheels have and upper and lower
grease zerk at each pivot. Due to constant movement,
these should be lubricated on 80–hour intervals
Figure 18