Instructions Manual

Pub. #OM17-MSP3
6-19
Updating Data Logger Firmware
1. Shut off the power of the Data Logger.
2. Copy the firmware on the SD card. (firmware found at veristech.com software download site)
3. Put the SD card into the Data Logger.
4. Turn on the power of the Data Logger.
5. Press the RESET button on the rear panel and (1) key simultaneously.
Figure 7.2
6. Hold the (1) key and release the RESET button.
7. If you can see the following messages, then release the (1) key.
Figure 7.3
8. If you want to update new software, press (2) key.