Operating Instruction

4
USER INSTRUCTIONS
GENERAL INFORMATION
1.  WARNING!!
 This appliance shall not be used for space heating. This
information is based on safety considerations.
2. To eliminate risk of burns or re by reaching over heated
surfaceunits,cabinetstoragelocatedabovethesurfaceunits
shouldbeavoided.
3. AlIopeningsinthewallbehindtheapplianceandintheoor
undertheapplianceshallbesealed.
4. Keep appliance area clear and free from combustible
materials,gasoline,andotherammablevapors.
5. Donotobstructtheowofcombustionandventilationair.
6. Disconnect the electrical supply to the appliance before
servicing.
7. Whenremovingapplianceforcleaningand/orservice;
A. Shutoffgasatmainsupply.
B. DisconnectACpowersupply.
C. Disconnectgaslinetotheinletpipe.
D. Carefullyremovetherangebypullingoutward.
 CAUTION:Rangeisheavy;usecareinhandling.
7. Electrical Requirement
Electrical installation should comply with national and local
codes.
8. Air Supply and Ventilation
 Theinstallermustreferstolocal/nationalcodes.
9. Gas Manifold Pressure
 Naturalgas-4.0”W.C.P.
 LP/Propane-11.0”W.C.P.
10. Themisuseofovendoor(e.g.stepping,sitting,orleaningon
them)canresultinpotentialhazardsand/orinjuries.
11. Wheninstallingorremovingtherangeforservice,arollinglift
jackshouldbeused.Donotpushagainstanyoftheedgesof
therangeinanattempttoslideitintooroutoftheinstallation.
Pushingorpullingarange(ratherthanusingaliftjack)also
increases the possibility of bending the leg spindles or the
internalcouplingconnectors.

WARNING!!
ELECTRICAL GROUNDING INSTRUCTIONS
The range must be electrically grounded in accordance with
local codes or, in the absence of local codes, with the National
Electrical Code, ANSI/NFPA No. 70-latest edition.
Installation should be made by a Iicensed electrician.
FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE
PROPERLY GROUNDED.
If an external electrical source is utilized, the installation must
be electrically grounded in accordance with local codes or, in
the absence of local codes, with the national Electrical Code,
ANSI/NFPA70.
REPLACEMENT PARTS
Only authorized replacement parts may be used in performing
serviceontherange.Replacementpartsareavailablefromfactory
authorizedpartsdistributors.Contactthenearestpartsdistributor
inyourarea.