Install Guide

1414

PRESSURE REGULATOR INSTALLATION

STEP 1

Mount the 1/2” NPT (conical) male connector to the pressure regulator and

tighten by using a wrench.

Do not over tighten the connector.

Over tightening may crack regulator.

STEP 2

Assemble the 1/2” NPT connector + pressure regulator group to the extension pipe interposing the gasket supplied.

The regulator cover must be oriented toward the front side of the range.

IMPORTANT: use two wrenches to tighten the connection.

Insert the extension pipe into the supplied support bracket “B” as shown:

• bend in the metal tab 90 degrees to allow the pipe to be tted into the bracket (detail #1);

• bend the metal tab back into its original position to secure (detail #2).

Fig. 2.3

Fig. 2.2

Arrow

Regulator cover

Lock

90°

Gasket Arrow