Install Guide

1818

WARNING:

• Do not remove storage

drawer while hot.

• Do not remove storage

drawer during operation.

• Be sure storage drawer is

empty before removing.

• Always position your hand

below the front panel to

open/close the storage

drawer.

CONVERSION TO LP/PROPANE GAS (OR CONVERSION BACK TO THE ORIGINAL GAS -

NATURAL GAS)

Every range is provided with a set of injectors for the various types of gas.

Select the injectors to be replaced according to the “INJECTORS TABLE”.

The nozzle diameters, expressed in hundredths of a millimetre, are marked on the body of each injector.

CAUTION: Save the injectors removed from the appliance for future use.

SETTING THE PRESSURE REGULATOR

The pressure regulator is accessible by removing the storage drawer; the pressure regulator is positioned on the rear right side of the

range (g. 2.9).

To remove the storage drawer:

1. Open the drawer completely (g. 2.8)

2. Move down the lever of left guide (g. 2.8a) and up the lever of right guide (g. 2.8b).

3. Remove the drawer holding the levers in the same position (g. 2.8).

Fig. 2.8a

Fig. 2.8

Fig. 2.8b