XB-8000 | XB-6000 INSTALL GUIDE
Congratulations on your purchase. Your XB-8000 / XB-6000 AIS Transponder is a Class B AIS Transponder with integrated NMEA 2000 and WiFi* connectivity. CONNECTIONS • LED Status • AIS/VHF antenna The XB provides information to improve your situational awareness and assist in 185mm (7 1/4”) avoiding collisions at sea. Because it consumes very low power it may be left • USB turned on whenever your vessel is underway.
VHF ANTENNA POWER AND DATA • A dedicated VHF antenna or Vesper Marine AIS/VHF Antenna Splitter is required. A 2m (6.5’) cable with attached 10 pin connector is supplied for connecting the XB to power, other devices over NMEA 0183 and an external silent mode switch. You may extend this cable as necessary. • Make sure your VHF antenna is an omni-directional antenna designed for the marine band (156-162MHz) and is well tuned at the AIS end of the band (VSWR 2:1 or less at 162MHz).
NMEA 2000 WIFI The XB can be connected to a NMEA 2000 network to enable AIS and GPS data to be sent to other NMEA 2000 devices. The XB can also receive and make use of data sent from NMEA 2000 sensors. Access Point Mode (default) (FOR XB-8000 ONLY) • Data Packets (PGN’s) supported are defined below. • A drop cable, T connection and network extension cable are required to connect the XB to your NMEA 2000 network.
CONFIGURATION • Before the XB can transmit your position you must configure your vessel details and enter a valid MMSI number. Your MMSI may have been entered already by your dealer. You must have an assigned MMSI for your vessel. If you do not have an assigned MMSI, contact the relevant authority in your country.
TECH SPECS STATUS LED TROUBLESHOOTING Size 200mm wide x 130mm high x 60mm depth (7 7/8” x 5 1/8” x 2 3/8”) Power supply 12-24 VDC 2A max, 3W nominal Environmental Watertight (USCG CFR-46, IPx7) Operating temperature -25°C to +55°C (-13°F to 131°F) Storage temperature -25°C to +80°C (-13°F to 176°F) Serial data 1 USB port (isolated), 1 NMEA input (isolated RS422), 1 NMEA output (non-isolated RS422) Data port impedance NMEA input: 96k ohm, NMEA output: 28 ohm NMEA 0183 output ALR, RMC, GSV, G
WARNINGS This AIS Transponder works in conjunction with other vessels and systems such as other AIS transponders and GPS devices. The accuracy of this device and the AIS system can be affected by many factors, including equipment failure or defects, environmental conditions and incorrect installation, handling or use. Vesper Marine does not warrant that this product is error-free. It is the user’s responsibility to exercise common prudence and navigational judgement.
NOTES WARRANTY This transponder is warranted, when properly installed and used, to be free from defects in materials or workmanship for two years from the date the product was purchased by the first retail customer. This warranty applies to the original retail purchaser only and is not transferable. Within this period, Vesper Marine will, at its discretion, repair or replace any components which fail in normal use.
Phone +64 9 950 4848 | Email info@vespermarine.com Fax +64 9 950 4085 | Web www.vespermarine.com Follow us on Facebook | www.facebook.com/vespermarine Copyright © 2012, Vesper Marine Ltd. AIS WatchMate, WatchMate Vision and WatchMate Wheel are trademarks of Vesper Marine Ltd. All other products are trademarks or registered trademarks of their respective owners.
