Product Manual A
3
MAINTENANCE
• Only trained and authorized personnel should be permitted to
maintain, repair, and inspect the unit.
• Keep usage area dry, clean, and well ventilated.
• To avoid fire hazards, have fire protection equipment present at
all times during any maintenance or repair. Do not use open pans
or containers of flammable fluids.
• Safety devices shall be inspected at monthly intervals and
maintained to a safe operating condition. A maintenance log
must be kept.
• Electrical components shall be maintained and inspected for
safe operation.
• The battery electrolyte level should be checked before charging
the battery. The level should be maintained at 1/2 inch above the
plates. If the level is low, add approved water before charging. Do
not overfill. It is not necessary to
charge the battery every day if there is more than 1/3 left, however
the battery should be charged at least once a week.
• Disconnect batteries before working with the electrical system.
• When checking the hydraulic fluid level, make certain that the unit
is fully lowered and on a level floor. Remove the filler cap and
check the level of the fluid. Use a top quality hydraulic fluid. Do not
use hydraulic brake fluid.
• Before leaving the unit, stop the unit, lower the forks fully, turn off
the power, and remove the key.
• Before working on the unit, lower the forks fully, check that the
brake is working properly, turn off the power, and restrain the unit
using chocks or other restraining devices.
EPT-2047-30 • EPT-2547-30
SPECIFICATIONS
Note: The load capacity is based on the situation when the
center of gravity is located at the center of the length of the
forks. When the load's center of gravity is past the center of the
forks, the load capacity will be lessened compared to the center.
3000 lbs.
3.1” - 7.8”
20”W x 47” L
25”W x 47” L
5.9”
24”
3.1” x 3.75”
3” x 3.75”
28”W x 65”L x 49”H
3.2 mph
3.8 mph
0.7 kw
1.3 kw
Micro-processor motor controller
2x12V/70 AH
25 amp
671 lbs.
59.1”
Loading Capacity
Fork Service Range
Fork Size (2048)
Fork Size (2547)
Fork Width
Load Center
Drive Wheel
Load Wheel
Overall Size
Walking Speed w/ Load
Walking Speed Unloaded
Drive Motor
Lift Motor
Controller
Battery
Battery charger
Net Weight
Turning Radius