Technical data

VD01126
40
41 Raw water pump inspection
The rubber impeller of the outboard water
pump is not proof against running dry.
If the water supply has been blocked, it
may be necessary to replace the impeller.
Always carry a spare impeller on board.
42 Pump cover removal
Inspection where appropriate changing is
as follows:
• Closetheseacock.
• Remove the cover of the pump by
unscrewing the screws out of the hous-
ing.
43 Impeller removal
• Slidetheimpelleroffoftheshaftusing
a waterpump plier.
• Mark the impeller to ensure correct
re-installation if it is to be re-used. The
impeller must be installed in the same
position as removed.
4 Maintenance
Raw water pump inspection
Every 1000 operating hours.
VD01031VD01125
10
7