Specifications

21
Key LED Meaning
(Operating) (Indication)
Engine - If the LED is on the corresponding engine is in neutral.
Command
- If this is off the engine cannot be operated with the control lever.
- If this is on the engine can be operated with the control lever.
Warm/Sync
- While the LED flashes WARM-UP is in progress, i.e. the engine(s) can run at increased revolutions
while the gearbox remains in neutral.
- When the LED is on the revolutions of both engines will be synchronized. The right-hand lever
controls both engines and the right-hand trim control controls both trims (if present).
Warm/Sync
- Make sure that both levers of the active control lever are set to neutral. Press the key Warm/sync
and hold this in for at least three seconds to switch on the WARM-UP.
Command
- Make sure that the control lever is set to neutral. Press the key Command and hold this in for at
least three seconds, after which the engine can be operated.
All LEDs flashing - There are faults in the engine controls.
3 Use
Control lever
Activate the operating lever as follows:
• Putthelever(s)intheneutralposition.
• Press key Command and hold this
pressed in for at least three seconds.
• The Command LED will come on and
the Warm/Sync LED will begin to flash.
The engine control is now in position
‘Warm-up’.
• Press key Warm/Sync and hold this
pressed in for at least three seconds
with the lever(s) in neutral in order to be
able to control the engines fully.