Specifications
22
Control lever
3 Use
3 Warming up the engine
• Make sure that the lever(s) is (are) in
neutral.
• PresskeyWarm/Syncandholdthisin
for at least three seconds.
• TheWarm/SyncLEDwillbegintoflash
and the warm-up function is active.
It is now possible to increase revolutions
without the gearbox being engaged.
• Thewarm-upfunctioncanbeswitched
off by pressing the key Warm/Sync
again and holding it in for at least three
seconds while the lever(s) is (are) in
neutral. The Warm/Sync LED will now
stop flashing. The engine(s) and the
gearbox (es) can now be operated.
4 Taking over control where there
are two control positions
Control can be transferred to another con-
trol position as follows.
When the vessel is not moving:
• Make sure that the lever(s) is (are) in
neutral.
• Press key Command and hold this in
for at least three seconds.
• The Command LED will come on and
the Warm/Sync LED will begin to flash.
• PresskeyWarm/Syncandholdthisin
for 3 seconds.
The engine(s) and the gearbox (es) can
now be controlled from this position.
During sailing:
• Set the lever(s) at the position where
control is to be taken over to the same
positions as the control lever that is to
relinquish control.
• The Engine LED will begin to flash as
soon as the requesting control lever is
correctly set relative to the control lever
that is to relinquish control (with a mar-
gin of 10°).
• When both levers are in the correct
position (and thus the corresponding
Engine LEDs are flashing) it is possible
to take over the control by pressing
key Command and holding this in for 3
seconds.