Specifications

23
Control lever
3 Use
Important: the function running in sync
is only available for systems with two
engines.
This function makes it possible to control
both engines using only one lever.
When in this position both reverse cou-
plings will be set in the same position and
the engines will run at the same speed.
Control of both engines is transferred to
the right-hand lever by pressing both keys
Engine and holding these in for three sec-
onds with the levers in neutral.
The function running in sync is shown by
the Warm/Sync LED and the Command
LED being on permanently, except when
in neutral when all LEDs are on perma-
nently.
Control of the engines is transferred back
to the corresponding levers by setting the
two levers to neutral and pressing keys
Engine again and holding these in for
three seconds. The Warm/Sync LED will
now be off.
5 Running in sync