Specifications

48
VD00109
9 Empty water separator
Empty the separately installed water sepa-
rator/fuel filter:
• Openthedrainplugatthelowersideof
the filter.
• Drain the water and close the drain
plug.
Note : The water separator is not within
the scope of supply but installation is
required!
10 Bleeding
After the water separator/fuel filter has
been drained, the air has to be bled from
the fuel system
The fuel system is self-bleeding.
Turn the key in the ignition lock to ‘ON’
and leave the key in this position for 30
seconds. The fuel pump will now bleed
the system.
11 Start the engine
Operate the starter switch until the engine
fires; release the starter switch if the engine
does not fire within 6 seconds. Wait until
the starter motor has stopped before mak-
ing a new attempt to start the engine.
Repeat the above if the engine cuts out
after a short time.
4 Maintenance
Draining of water from the water separator/fuel filter
Every 100 operating hours.
VD00107
VD00027