Owner`s manual

9
ASSEMBLYPROCEDURES
**Disconnectsparkplugleadfirst**
1. Fit one of the bolts through the handle hole
from the inside and into the square hole in
mounting bracket of the base. place washer
then spring washer and secure with nut but do
not fully tighten at this stage.
2. Repeat the same step for the remaining three
securing bolts.
3. Tighten all four nuts securely.
Attaching the lower handles
Attaching upper handle
Attaching the throttle control
Secure the
throttle cable to
the lower handle
with the cable clip.
Attach the throttle control to the inside
of the upper handle, so that the lever
lifts upward toward the user.
Attach the upper handle to the
lower handles using the knobs
and bolts provided. The knobs
should be on the outside.
Lower
handle
Upper
handle
Upper
handle
Lower
handle
Upper
handle
Secure the
throttle cable to
the lower handle
with the cable clip.
Attach the throttle control to the inside
of the upper handle, so that the lever
lifts upward toward the user.
Attach the upper handle to the
lower handles using the knobs
and bolts provided. The knobs
should be on the outside.
Lower
handle
Upper
handle
Upper
handle
Lower
handle
Upper
handle
Secure the
throttle cable to
the lower handle
with the cable clip.
Attach the throttle control to the inside
of the upper handle, so that the lever
lifts upward toward the user.
Attach the upper handle to the
lower handles using the knobs
and bolts provided. The knobs
should be on the outside.
Lower
handle
Upper
handle
Upper
handle
Lower
handle
Upper
handle
• Attachtheupperhandlesusingtheknobs/togglesand
bolts provided. The knobs/toggles should be on the
outside.
• Attachthethrottlecontroltotheinsideofthe
upper handle, so that the lever lifts upward
toward the user
• Securethethrottlecabletothe
lower handle with the cable clamp
supplied.
Model
All 16in Steel Models