Owner`s manual

ASSEMBLYPROCEDURES
11
Attaching the lower handles straight and loop
Attaching upper handle
Attaching the throttle control
Lower handle
Bolt
Nut
Painted
saddle plate
Unpainted
saddle
plate
Chassis
Chassis
Lower
handle
Painted
saddle
plate
Nut
STOP
START
RUN
Secure the
throttle cable to
the lower handle
with the cable tie.
Attach the throttle control to the inside
of the upper handle, so that the lever
lifts upward toward the user.
Attach the upper handle to the
lower handles using the knobs
and bolts provided. The knobs
should be on the outside.
Lower
handle
Upper
handle
Upper
handle
Lower
handle
Upper
handle
Model
All 18in Steel Models
**Disconnectsparkplugleadfirst**
1. Place one of the bolts through one of the
unpainted saddle plates
2. Whilst holding open the rear catcher flap,
insert the bolt and saddle plate through the
rear of the mower and up through the small
hole in the left hand side of the lawnmower
chassis, from underside.
3. From the topside, place lower handle
(straight or loop), then one of the black
painted saddle plates onto the protruding
bolt.
4. Thread one of the nuts onto the top of the
bolt, and tighten with fingers
5. Push and hold the bolt up so that the
square shoulder of the bolt is located in
the unpainted saddle plate then tighten
thenutto22Nm.theboltislocatedinthe
unpainted saddle plate then tighten the nut
to22Nm.
6. Repeat on other side.
Comfort Grip & Straight Handles