Owner`s manual

ASSEMBLYPROCEDURES
13
Aerogrip Handle Assembly
Assembly Procedure
1 Laytheupperhandleacrosstheenginecowlofthelawnmower,withthebendfacing
down (see Fig. 1).
2 Position the ends of the upper handle over the lower handles at the pivot joint, so that
the holes are all aligned.
3 Push the locking bolt through the holes of both handles (making sure the washer is on
the lever side). (see Fig. 2).
4 Place lock nut on the inside of the handles. Tighten the nut while checking the operation
of the lever (over tightening will make lever hard to operate and deform, under tightening
will result in loose handles).
5 Position the centre knuckle in between the lower handles firmly push the knuckle into
the ends of the lower tubes.
6 For2strokemodelswiththecentresnorkel,therecessfacesupwards.Othermodels
have the knuckle recess facing downward. (see Fig. 3).
Your Aerogrip handle may require some
assembly before its first use. If the upper
and lower handle have been supplied
unattached, follow these instructions
below.
PIVOT JOINT COMPONENTS
ITEM QTY
1.Lowerhandles x2
2.Centreknuckle  x1
3.Locknut  x2
4.Washer  x2
5.Lever  x2
6.Upperhandles x1
1 1
55
66
44
2
3
3
Fig 1. Fig 2. Fig 3.
Fig. 1 Fig. 2 Fig. 3