Instruction Manual

CMOR Dome
Videoswitch Page 25 Vc601i.doc
The default password 111100 may be changed if required. Take care to make a note of the
new password.
5.3.6 Datum Check
The dome can be set to perform a datum check every 24 hours, at midnight. This means
that the dome will pan and tilt for a few seconds while it performs a self test and checks its
alignment. It will revert to an existing preset or tour when the process is complete. It is
recommended that the 24 hour option is selected (default)
5.3.7 Install date/time
The date and time of install may be set here to provide a record for future service or
maintenance purposes.
5.3.8 Clear Settings
5.3.8.1 Clear configuration
To clear the menu configuration to the factory defaults, enter this menu, use UP to select
YES and go LEFT to exit.
5.3.8.2 Clear all presets
To clear all the presets, enter this menu, use UP to select YES and go LEFT to exit.
5.3.8.3 Clear all tours
To clear all the tours, enter this menu, use UP to select YES and go LEFT to exit.
5.3.8.4 Clear privacy masks
To clear all privacy settings, enter this menu, use UP to select YES and go LEFT to exit.
5.3.8.5 Clear everything
To clear the configuration, presets and tours, enter this menu, use UP to select YES and go
LEFT to exit.
5.3.8.6 Reboot
To restart the dome (equivalent to power cycling), enter this menu, use UP to select YES
and go LEFT to exit.
Note that any unsaved changes to the configuration will be lost when this is done.
5.3.8.7 Diagnostic Info
• System
• Status
• Camera
• Telemetry