Instruction Manual

CMOR Dome

Videoswitch Page 31 Vc601i.doc

5 Move joystick/arrow key right Cross lines appear on screen

6 Move camera to required view

Select OK (Vi K/B) or 01+preset (Pelco K/B), or Preset, 10

,1 (on DS2) or wait 15 seconds until a red mask patch

appears

Red mask patch appears

8 Scroll to next MASK number (using arrow keys or joystick

UP/DOWN)

Blue mask patch appears

9 Move joystick or arrow key to the RIGHT Cross lines appear

10 For each new mask position, repeat steps 4 to 7

12 When all mask positions have been created , exit menus

& save by moving joystick left TWICE

‘Saving config…’ (appears on

bottom left of screen)

5.10 Alarms

If the alarm option is installed in the power supply, the dome will go to presets when an

alarm occurs. Alarms 1 to 16 map to presets 1 to 16 respectively.

Note that if the alarms are connected directly to the digital recorder (DVR) rather than the

alarm option, the following settings have no effect.

5.10.1 New alarm dwell

When a new alarm occurs, the dome will go to the corresponding preset.

If multiple alarms occur, the presets will be called up in sequence. However, the dome will

wait at each preset position for the dwell time set by this option (in seconds).

5.10.2 Alarm cycle time

If alarms still exist after all alarm presets have been visited for the New alarm dwell time, the

presets of the still active alarms will now be toured using the cycle time (in seconds)

specified in this option.