Installation Guide
Table Of Contents
- About this Document
- Disclaimer
- Product Information
- Handling Instructions
- Installation Instructions
- Limited Warranty
- ProPress approved applications
- Minimum distance between press fittings
- ProPress standard jaws clearance requirements
- ProPress standard jaws clearance requirements between tube, wall, and floor
- ProPress compact jaws clearance requirements
- ProPress compact jaws clearance requirements between tube, wall, and floor
- ProPress rings dimensions
- ProPress rings with V1 Actuator clearance requirements
- ProPress rings with V2 Actuator clearance requirements
- ProPress rings with V1 Actuator clearance requirements between tube, wall, and floor
- ProPress rings with V2 Actuator clearance requirements between tube, wall, and floor
- ProPress rings with C1 Actuator clearance requirements between tube, wall, and floor
- ProPress XL-C rings dimensions
- ProPress XL-C rings clearance requirements
- ProPress XL-C rings clearance requirements between tube, wall, and floor
- Minimum distance between existing soldered or brazed fitting and ProPress fitting
- Minimum distance between existing ProPress fitting and soldered or brazed fitting
- Minimum insertion depths for ProPress ½" to 2" fittings
- Insertion depths for ProPress ½" to 2" no-stop couplings
- Insertion depths for ProPress ½" to 2" extended no-stop couplings
- Minimum insertion depths ProPress 2½" to 4" fittings
- Insertion depths for ProPress 2½" to 4" no-stop couplings
Installation Instructions
34 of 44
IM-PP 724607 0320 ProPress
For hard copper tubing in 2½" to 4".
4.8.2 Viega ProPress 2½" to 4" Installation
WARNING!
Read and understand all instructions for
installing Viega ProPress 2½" to 4" ttings.
Failure to follow all instructions may result in
extensive property damage, serious injury, or
death.
Use only rings that are compatible with ProPress
2½" to 4" ttings.
■ Use of incompatible rings will result in an improper
connection.
■ Do not mix actuators and rings from dierent
manufacturers.
■ Do not use rings intended for XL Bronze ttings.
▶ Check the sealing element, separator ring, and grip ring for correct t:
■ The tube end is not bent or damaged.
■ The tube is deburred.
■ The correct sealing element is in the tting.
Illustration demonstrates proper t of grip ring, separator ring, and sealing
element.