Installation Guide
Table Of Contents
- About this Document
- Disclaimer
- Product Information
- Handling Instructions
- Installation Instructions
- Limited Warranty
- ProPress approved applications
- Minimum distance between press fittings
- ProPress standard jaws clearance requirements
- ProPress standard jaws clearance requirements between tube, wall, and floor
- ProPress compact jaws clearance requirements
- ProPress compact jaws clearance requirements between tube, wall, and floor
- ProPress rings dimensions
- ProPress rings with V1 Actuator clearance requirements
- ProPress rings with V2 Actuator clearance requirements
- ProPress rings with V1 Actuator clearance requirements between tube, wall, and floor
- ProPress rings with V2 Actuator clearance requirements between tube, wall, and floor
- ProPress rings with C1 Actuator clearance requirements between tube, wall, and floor
- ProPress XL-C rings dimensions
- ProPress XL-C rings clearance requirements
- ProPress XL-C rings clearance requirements between tube, wall, and floor
- Minimum distance between existing soldered or brazed fitting and ProPress fitting
- Minimum distance between existing ProPress fitting and soldered or brazed fitting
- Minimum insertion depths for ProPress ½" to 2" fittings
- Insertion depths for ProPress ½" to 2" no-stop couplings
- Insertion depths for ProPress ½" to 2" extended no-stop couplings
- Minimum insertion depths ProPress 2½" to 4" fittings
- Insertion depths for ProPress 2½" to 4" no-stop couplings
Installation Instructions
36 of 44
IM-PP 724607 0320 ProPress
▶ Open XL-C ring and place at right angles on the tting.
▶ Ensure that the XL-C ring is engaged on the tting bead.
▶ Open the V2 Actuator and connect the V2 Actuator to the XL-C ring.
▶ Look at insertion depth mark on the tube to make sure that the tube is
properly inserted into the tting.
▶ Hold the trigger until the Actuator has engaged the XL-C ring.
WARNING!
Keep extremities and foreign objects away from XL-C
ring and V2 Actuator during pressing operation to prevent
injury or incomplete press.
▶ Release the V2 Actuator from XL-C ring.
▶ Remove the XL-C ring from tting upon completion of the press.
▶ Remove product instruction label from tting to indicate that press
has been completed.