Installation Guide
Table Of Contents
- About this Document
- Disclaimer
- Product Information
- Handling Instructions
- Installation Instructions
- Limited Warranty
- ProPress approved applications
- Minimum distance between press fittings
- ProPress standard jaws clearance requirements
- ProPress standard jaws clearance requirements between tube, wall, and floor
- ProPress compact jaws clearance requirements
- ProPress compact jaws clearance requirements between tube, wall, and floor
- ProPress rings dimensions
- ProPress rings with V1 Actuator clearance requirements
- ProPress rings with V2 Actuator clearance requirements
- ProPress rings with V1 Actuator clearance requirements between tube, wall, and floor
- ProPress rings with V2 Actuator clearance requirements between tube, wall, and floor
- ProPress rings with C1 Actuator clearance requirements between tube, wall, and floor
- ProPress XL-C rings dimensions
- ProPress XL-C rings clearance requirements
- ProPress XL-C rings clearance requirements between tube, wall, and floor
- Minimum distance between existing soldered or brazed fitting and ProPress fitting
- Minimum distance between existing ProPress fitting and soldered or brazed fitting
- Minimum insertion depths for ProPress ½" to 2" fittings
- Insertion depths for ProPress ½" to 2" no-stop couplings
- Insertion depths for ProPress ½" to 2" extended no-stop couplings
- Minimum insertion depths ProPress 2½" to 4" fittings
- Insertion depths for ProPress 2½" to 4" no-stop couplings
Installation Instructions
22 of 44
IM-PP 724607 0320 ProPress
▶ Visually inspect replacement sealing element. Ensure there are no
defects, scratches, or burrs, is free of debris, and is coated with lubricant.
▶ Pinch the sealing element and place it fully inside the tting, below
the separator and grip rings.
▶ Carefully pull the sealing element up into the channel below the
separator ring. Ensure proper, concentric seating of grip ring,
separator ring and sealing element before installation.
▶ Carefully reach past the grip ring, pinch and remove the sealing
element from the tting.
WARNING!
Grip ring is extremely sharp, use gloves or extreme caution
when reaching into tting.
CAUTION!
If reusing the sealing element ensure the sealing element does
not make contact with grip ring as this can cause damage.