Installation Guide
Table Of Contents
- About this Document
- Disclaimer
- Product Information
- Handling Instructions
- Installation Instructions
- Limited Warranty
- ProPress approved applications
- Minimum distance between press fittings
- ProPress standard jaws clearance requirements
- ProPress standard jaws clearance requirements between tube, wall, and floor
- ProPress compact jaws clearance requirements
- ProPress compact jaws clearance requirements between tube, wall, and floor
- ProPress rings dimensions
- ProPress rings with V1 Actuator clearance requirements
- ProPress rings with V2 Actuator clearance requirements
- ProPress rings with V1 Actuator clearance requirements between tube, wall, and floor
- ProPress rings with V2 Actuator clearance requirements between tube, wall, and floor
- ProPress rings with C1 Actuator clearance requirements between tube, wall, and floor
- ProPress XL-C rings dimensions
- ProPress XL-C rings clearance requirements
- ProPress XL-C rings clearance requirements between tube, wall, and floor
- Minimum distance between existing soldered or brazed fitting and ProPress fitting
- Minimum distance between existing ProPress fitting and soldered or brazed fitting
- Minimum insertion depths for ProPress ½" to 2" fittings
- Insertion depths for ProPress ½" to 2" no-stop couplings
- Insertion depths for ProPress ½" to 2" extended no-stop couplings
- Minimum insertion depths ProPress 2½" to 4" fittings
- Insertion depths for ProPress 2½" to 4" no-stop couplings
Installation Instructions
33 of 44
IM-PP 724607 0320 ProPress
▶ Pull retaining pin out of press tool.
▶ Insert appropriate jaw.
▶ Push in retaining pin until it locks the jaw in place.
▶ Open the jaw and place at right angle on the tting.
▶ Look at insertion depth mark on the tube to make sure that the tube is
properly inserted into the tting.
▶ Hold trigger on press tool until press jaws have fully engaged the
tting. Jaws will automatically release after a full press is made.
▶ After pressing, open the jaws.
▶ Remove the press tool.
▷ Fitting is securely pressed.
WARNING!
Keep extremities and foreign objects away from press tool
during pressing operation to prevent injury or incomplete
press.