Unit installation

37
Setting
Rated burner heating output
Setting
Reduced burner heating output
Parameter set 4
≙
246 kW
1 2 3 4 5 6 7 8
ONON
Parameter set 10
≙
173 kW
1 2 3 4 5 6 7 8
ON
Parameter set 5
≙
311 kW
1 2 3 4 5 6 7 8
ONON
Parameter set 11
≙
218 kW
1 2 3 4 5 6 7 8
ONON
Acknowledging a parameter set
A flashing "P" is shown under "Status" if a parameter set is changed via the DIP switch
or if the burner control unit has been replaced. The numbers shown under Service
indicate the selected parameter set (see page 36).
Status Service
"U" will appear under "Service" if an invalid DIP switch setting is selected.
Status Service
1. Check the DIP switch setting; if
required, change it in accordance
with page 36 .
2.
Press b and a simultaneously for
approx. 2 s.
The selected parameter setting has
been accepted when "P" no longer
flashes and the memory LED illumi-
nates.
Burner control unit
(cont.)
5692 907 GB