Technical data

5584 069 - 05

Vitocrossal 200, CM2 400, 500, 620 and 620 TX Installation

Boiler

Cross Bar

1. Install the cross bar (using the rear holes) to the top

rail with two screws.

Mounting the Burner

1. Insert six M12 threaded studs into the boiler door.

2. Put gasket in place.

3. Position the burner at the boiler door, guiding the

burner gauze assembly carefully through the opening.

Note: Do not remove the burner gauze assembly

protection during the installation to the boiler

door. Ensure that the burner gauze assembly

is kept free from the thermal insulation block

fibres.

Note: The burner should be fitted by two people

or with the use of a lifting aid. Take care not

to damage the electrodes and burner gauze

assembly.

4. Tighten the six nuts M12 diagonally and torque

to a minimum of 13 lb/ft (18 Nm).

Note: All parts required for installing the burner are

contained in the burner carton.

5. Open the boiler door and carefully remove the burner

gauze assembly protection.

6. Close boiler door and tighten the six bolts M12

diagonally. Torque to 29.5 lb/ft (40 Nm).

CAUTION

Faults may occur if the burner gauze assembly is

contaminated or incorrectly installed. Ensure that the

combustion chamber and the burner gauze assembly

are kept free from the thermal insulation block fibres.

Refer to the Service Instructions when checking

for electrode gap or burner gauze damage.