Operating instructions

Installation

Changing the control thermostat setting (if required)

Conversion to 100 or 110 ºC

In the delivered condition, the control thermostat is set to 95 ºC.

1. Lever out and remove rotary

selector "R".

2. Using a pair of pointed pliers,

break off the cams from the stop

dial which are identified in the

illustration.

75 to 100 ºC

A, B 75 to 110 ºC

Note

Observe the setting of coding

address "06".

3. Fit rotary selector "R", so that the

marking lies at the centre of the

selected range.

Turn rotary selector "R"

clockwise to the end stop.

Please note

Excessive DHW temperatures

can damage the DHW cylinder.

If the system is operated in

conjunction with a DHW

cylinder, ensure that the

maximum permissible DHW

temperature is not exceeded.

If necessary, install suitable

safety equipment for this

purpose.

5862730GB

A B