User Guide

24
5.1.4. PIP menu
Sub mode
PIP size
PIP position
PIP change
PIP source
PIP audio
PIP reset
Picture
Screen
Audio
PIP
Configuration 1
Off
Small
Bottom-Right
Action
VGA
Main
Action
Sub mode
Select the PIP (Picture-in-Picture) mode.
Choose from: {Off}/{PIP}/{POP}/{Quick swap}/
{PBP}.
PIP size
Select the size of the sub picture in the PIP
(Picture-in-Picture) mode.
Choose from: {Small} / {Medium} / {Large}.
PIP position
Select the position of the sub picture in the PIP
(Picture-in-Picture) mode.
{Bottom-Right} / {Bottom-Left} / {Top-Right} /
{Top-Left}
PIP change
Exchange Main and PIP/POP/PBP/Quick swap
input signal.
PIP Source
Select the input signal for the sub picture.
PIP audio
Select the audio source in the Sub mode.
• {Main} - Select audio from the main picture
• {Sub} - Select audio from the sub picture.
PIP reset
Reset all settings in the PIP menu to factory preset
values.
NOTES
:
• The PIP function is available only for certain
signal source combinations as shown in the
table below.
• The availability of the PIP function will also
depend on the resolution of the input signal
being used.
HDMI1 HDMI2 DVI DisplayPort VGA MediaPlayer Browser
PDF
Player
Custom
HDMI1 O X X O O X X X X
HDMI2 X O X O O X X X X
DVI X X O O X X X X X
DisplayPort O O O O O O O O O
VGA O O X O O O O O O
Media
Player
X X X O O O X X X
Browser X X X O O X O X X
PDF Player X X X O O X X O X
Custom X X X O O X X X O
(O: PIP function available, X: PIP function
unavailable)
5.1.5. Config1 menu
Switch on state
Panel saving
RS232 routing
Boot on source
WOL
Power LED light
Network
Configuration1 reset
Factory reset
Picture
Screen
Audio
PIP
Configuration 1
Last status
Action
RS232
Action
Off
On
On
Action
Action
Switch on state
Select the display status used for the next time
you connect the power cord.
• {Power off} - The display will remain off
when the power cord is connected to a wall
outlet.
• {Forced on} - The display will turn on when
the power cord is connected to a wall outlet.
• {Last status} - The display will return to the
previous power status (on/off/standby) when
removing and replacing the power cord.
Panel saving
Choose to enable the panel saving functions and
thus reduce the risk of “image persistence” or
“ghost-imaging”.
• {Brightness} - Select {On} and the image
brightness will be reduced to an appropriate
level. The Brightness setting in the Picture
menu will be unavailable when selected.
• {Pixel shift} - Select the time interval ({Auto}
/ {10 ~ 900} Seconds/ {Off}) for the display
to slightly expand the image size and shift
the position of pixels in four directions (up,
down, left, or right). Activating Pixel Shift will
disable H Position, V Position and Zoom
Mode in the Screen Menu.
RS232 Routing
Select the network control port.
Choose from: {RS232} / {LAN->RS232}.