User Guide

Compliance Information

NOTE: This section addresses all connected requirements and statements regarding

regulations. Confirmed corresponding applications shall refer to nameplate labels and

relevant markings on unit.

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

NOTE: This equipment has been tested and found to comply with the limits for a

Class A/Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment generates, uses,

and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. Operation of

this equipment in a residential area is likely to cause harmful interference in which case

the user will be required to correct the interference at his/her own expense.

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Warning: To comply with the limits for the Class A/Class B digital device, pursuant to

Part 15 of the FCC Rules, this device must be installed in computer equipment certified

to comply with the Class A/Class B limits. All cables used to connect the computer and

peripherals must be shielded and grounded. Operation with non-certified computers or

non-shielded cables may result in interference to radio or television reception. Changes

and modifications not expressly approved by the manufacturer could void the user’s

authority to operate this equipment.

For Canada

CAN ICES-3 (A/B)/NMB-3(A/B)