User guide
Table Of Contents
- For Your Records
- Getting Started
- Package Contents
- Important Safety Warnings
- Connect Input and Output Devices
- Installation Steps
- Adjusting the Projector Angle
- Projector Placement Distance
- Using The Projector
- Control Buttons
- OnView Indicators
- Setup Main Menu
- Input Menu
- Image Menu
- Options Menu
- Other Information
- Specifications
- Timing Chart
- Troubleshooting
- Power Indicator Lights
- Screen Messages
- Maintenance
- Lamp Replacement
- Installing Battery (for remote control)
- Cleaning Instructions
- Air-Filter
- Customer Support
- LIMITED WARRANTY
- VIEWSONIC Projector
- Appendix
- Power Cord Safety Guidelines
- FCC Information
ViewSonic PJ853 8
E
N
G
L
I
S
H
OnView Indicators
Use the OnView
®
menus shown below to adjust the projected image.
To access and adjust the OnView screens do the following:
1
Press the MENU button on the projector control pad or remote control to access on-screen
options and display the SETUP Main Menu.
2
Press the ARROW buttons, as explained below, to select and adjust options that are displayed on
the screen.
NOTE:
After you have used the ARROW buttons to adjust a value, the value will automatically
apply after a few seconds.
Setup Main Menu
Timer Button
The TIMER button is on the remote control. You can set the timer from the OPTIONS
menu explained in the next section.
Use the Timer button to activate the on-screen timer.
-
Press once to display the time on the lower left part of the screen.
-
Press again to turn off the display.
Auto Button
Use the Auto button to automatically adjust the vertical position and horizontal
position, phase, and size.
SETUP Main Menu
RGB
The setup
RGB
menu displays 9 adjustment options.
1
Press an arrow button (▲▼) to display the menu.
2
Press the right or left arrow buttons to select a menu option other than Setup.
3
Press the up anddown arrow buttons to movethrough the Setup menu options.
4
After a menu option has been selected, use the right or left arrow buttons to
increase or decrease the value of the selected option.
SETUP Main Menu
Video
The
Video
setup menu displays 8 adjustment options.
1
Press an arrow button to display the menu.
2
Press the right or left arrow buttons to select a menu option other than Setup.
3
Press the up anddown arrow buttons to movethrough the Setup menu options.
4
After a menu option has been selected, use the right or left arrow buttons to
increase or decrease the value of the selected option.
Use the arrow buttons on the projector control pad or on the remote control to
move through the menuoptions and to increase or decrease the value of a selected
option.
0
-2
+1
0
0
100
100
800
SETUP INPUT OPT.IMAGE
BRIGHT
CONTRAST
V POSIT
H POSIT
H PHASE
H SIZE
COLOR BAL R
COLOR BAL B
ASPECT
BRIGHT
CONTRAST
SHARPNESS
COLOR
TINT
COLOR BAL R
COLOR BAL B
ASPECT
SETUP INPUT OPT.IMAGE
0
0
0
0
0
+1
+1
PJ853-.book Page 8 Wednesday, August 16, 2000 11:41 AM